Lcd Display Descriptions; Start-Up Sequence - Westinghouse WBRC 140F Series Installation & Start-Up Instructions

B. LCD DISPLAY DESCRIPTIONS
Figure 36 – LCD Display Detail
LCD also features a backlit lamp that will illuminate:

When a user action is detected (a button is pressed)

The display has timed out for approximately 2 minutes
C. START-UP SEQUENCE
After the appliance is powered ON, the LCD display shows a sequence of information. The icons will flash, followed by various
indicators that describe the appliance controller and software versions. It will take the appliance roughly 15 seconds to cycle through
the Start-Up Sequence.
Display Items
LCD Test
Category: 140F / 199F
Software Version for Front Panel
Software Version for Appliance
Hardware Version for Appliance
Table 23 – Start-Up Sequence
After start-up, the display appears as follows.
Figure 37 – Initial Display Screen Example
NOTE: The initial display screen will differ depending on a number of factors, including whether the appliance detects a call for heat or
hot water.
The Control System can operate through user and service modes that have specific LCD outputs and dedicated controls, including:

Changing the Set-Point Temperature

Lock Mode

Error Mode

Status Display Mode

Outdoor Temperature Mode
Time for Display
1 Sec
0.5 Sec
1 Sec
1 Sec
1 Sec
1 Sec
1 Sec
1 Sec
1 Sec
1 Sec
Remarks
All segments "ON"
All segments "OFF"
Pdn
0051
SPn
00.XX
SFn
XX.XX
Hdn
00XX
WHL-015 REV. 1.13.17
50