Ceiling Height Selection (Air Conditioner) - LG V-NET ACS PREMTA000 Installation & User Manual

INSTALLER'S SETTING OPTIONS
186
● At the Value 1 field, press the '▲', '▼' button to select the sensor location setting value and
press 'Done' button to apply the indoor temperature detection sensor location setting.
- If you do not press 'Done' button, your settings will not be applied.
h Sensor location setting value
- 01: remote controller
- 02: indoor unit
- 03: 2TH
Temperature sensor location
Remote controller
Indoor unit Operate the system with indoor unit's temperature sensor
Compare the temperatures of the indoor unit and the wired remote con-
Cooling troller and operate with the higher temperature (There are system oper-
2TH
Compare the temperatures of the indoor unit and the wired remote con-
Heating
troller and operate with the lower temperature
h 2TH function's operation characteristics may be different for each product.
h If no buttons are pressed for about 60 seconds after the setting, it automatically exits from the
setting mode.
Function
Operate the system with wired remote
controller's temperature sensor
ated with lower temperature)

Ceiling height selection (air conditioner)

This function adjusts the wind amount stages according to the ceiling height for the ceiling type
unit.
● Press and hold 'wireless remote controller signal receiver part' of the remote controller for 3
seconds or longer to enter the installer function.
● At the Code field select ceiling height setting code value '05'.
- You can press '▲', '▼' button to change the code value.
● In value1, use '▲', '▼' button to select ceiling height setting value, and then press 'Done' but-
ton to apply the ceiling height setting.
- If you do not press 'Done' button, your settings will not be applied.
h Ceiling height setting value
- 01: low
- 02: standard
- 03: high
- 04: very high
INSTALLER'S SETTING OPTIONS
187