Installer's Setting Options; How To Enter Installer Setting Mode; Installer Setting Code Table - LG V-NET ACS PREMTA000 Installation & User Manual

INSTALLER'S SETTING OPTIONS

178

INSTALLER'S SETTING OPTIONS

How to enter installer setting mode

! CAUTION
Installer setting mode configures the detailed function of the remote controller.
If the installer setting mode is incorrectly set, it may cause product failure, user injury, or prop-
erty damage. It must be set by an installation specialist who holds an installation license. If it is
installed or changed without installation license and without authorization, installer will be re-
sponsible for all malfunctions, which will result in voiding of any warranties or provision of free
technical service.
● When you press and hold the wireless remote controller signal receiver for 3 seconds or longer and
release it in the air conditioner or ventilation main screen, it enters the installer setting mode.
- When you enter from air conditioner screen, it enters air conditioner installer setting, and when
you enter from ventilation screen, it enters ventilation installer setting.
- If button is not pressed for at least 3 seconds, it will not enter the setting mode.
● In 'Input Code' screen, you can input code to carry out Installer Setting Function.
h During the input of the installer code, refer to the installer code If no buttons are pressed.
h If no buttons are pressed for about 60 seconds, it automatically exits from the setting screen.
!
NOTE
Some categories of the menu may not be displayed or menu name may differ depending on
your specific indoor unit model type.

Installer setting code table

<General air conditioner product code table>
Code Setting Mode
Value 1
001 : Cooling
1 Test Run
002 : Heating
Central control ad-
2 0~F : Group
dress setting
<ESP step>
001 : SLOW
002 : LOW
3 ESP
003 : MED
004 : HIGH
005 : POWER
001 : remote controller
4 Temperature sensor 002 : indoor unit
003 : 2TH
001: low
002: standard
5 Ceiling height
003: high
004: very high
001 : V-H
002 : F-H
6 Static pressure
003 : V-L
004 : F-L
Remote controller 000 : slave
7
master / slave setting 001 : master
Operation master /
000 : slave
8 slave setting
001 : master
(Mode Override)
Dry contact mode 000 : manual
9
setting 001 : automatic
Wind amount fixing 001 : variable
11
002 : fixed
Celsius / Fahrenheit 000 : Celsius
12
Switching 001 : Fahrenheit
000 : Old
13 Zone type 001 : New(4Zone)
002 : New(8Zone)
14 Zone number 002~008 : Installed number
Celsius control unit 000 : 1 °C control
17
setting 001 : 0.5 °C control
<Select mode>
Emergency Heater
18 000 : not use
Setting
001 : use
INSTALLER'S SETTING OPTIONS
179
Setting Value
Value 2 Value 3
0~F : Unit
<ESP setting value>
0~255
<Setup Low Ambient <Setup Fan speed>
Setup FAN 000 : fan off
Heating Operation> 001 : fan on
000 : not use
001 ~ 003 : Setting Step
001 ~ 015 : Setting Step
(step expand indoor unit)