Installation instruction
Installer Setting -Ceiling Height Selection
This function is to adjust FAN Airflow rate according to ceilingheight (only cassette model)
<Ceiling Height Selection Table>
Ceiling Height Level
01
Low
Decrease the indoor airflow rate 1 step from standard level
02
Standard
Set the indoor airflow rate as standard level
03
High
Increase indoor airflow rate 1 step from standard level
04
Super high
Increase indoor airflow rate 2 steps from standard level
❊
Ceiling height setting is available only for some products.
❊
Ceiling height of 'Super high' function may not exist depending on the indoor unit.
❊
Refer to the product manual for more details.
16 Wide Wired Remote Controller
1
Press
button for 4 seconds
to enter the installer setting
mode until timer segment
display "01:01".
2
Repeat pressing
button to select
Function code 05.
Function Code
Ceiling height
Ex) Setting Ceiling Height as 'Standard'.
3
Select ceiling height value by pressing
button.
(01:Low, 02:Standard, 03:High,
04:Super high)
4
Press
button to save or release.
5
Press
button to exit or
system will automatically exit
after 25 seconds without any
input.
Description
Installer Setting -Static Pressure Setting
This function is applied to only duct type. Setting this in other cases will cause malfunction.
<Static Pressure Setting Table>
Pressure selection
01
F-L
02
F-H
03
V-L
04
V-H
Installation instruction
1
Press
button for 4 seconds
to enter the installer setting
mode until timer segment
display "01:01".
2
Repeat pressing
button to select
Function code 06.
Function Code
Pressure
3
Select static pressure by pressing
button.
(01:V-H, 02:F-H, 03:V-L, 04:F-L)
4
Press
button to save or
release.
5
Press
button to exit or
system will automatically exit
after 25 seconds without any
input.
Function
Zone state
ESP standard value
Fixed
Low
Fixed
High
Variable
Low
Variable
High
Owner's & Installation Manual 17