Table of Contents
Advertisement
2
Hardware Installation
2.6.6 IrDA Connector
Connect the cable connector from your IR module to the IR
connector (J13).
BIOS Setting
Configure IR in the Integrated Peripherals submenu ("Super IO
Device" field) of the BIOS.
Driver Installation
You may need to install the proper drivers in your operating system
to use the IR function. Refer to your operating system's manual or
documentation for more information.
50
Note:
The sequence of the pin functions on some IR cable may be
reversed from the pin function defined on the system board.
Make sure to connect the cable connector to the IR connector
according to their pin functions.
VCC
1
N. C.
IRRX
Ground
IRTX
5
Advertisement
Table of Contents
