Table of Contents
Advertisement
3
BIOS Setup
KB Power On Password
Move the cursor to this field and press <Enter>. Enter your pass-
word. You can enter up to 5 characters. Type in exactly the same
password to confirm, then press <Enter>.
The power button will not function once a keyboard password has
been set in this field. You must type the correct password to power-
on the system. If you forgot the password, power-off the system and
remove the battery. Wait for a few seconds and install it back
before powering-on the system.
Hot Key Power On
This field is used to select a function key that you would like to use
to power-on the system.
Onboard FDC Controller
Enabled Enables the onboard floppy disk controller.
Disabled Disables the onboard floppy disk controller.
Onboard Serial Port 1
Auto
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
Disabled
UART Mode Select
This field is used to select the type of IrDA standard supported by
your IrDA device. For better transmission of data, your IrDA
peripheral device must be within a 30
of 1 meter.
UR2 Duplex Mode
Half
Full
80
The system will automatically select an I/O address
for the onboard serial port.
manually select an I/O address for the onboard
serial port.
Disables the onboard serial port.
Data is completely transmitted before receiving data.
Transmits and receives data simultaneously.
Allows
o
angle and within a distance
you
to
Advertisement
Table of Contents
