DFI G7S300-B User Manual page 73

IDE Primary Master/Slave UDMA and IDE Secondary Master/
Slave UDMA
These fields allow you to set the Ultra DMA in use. When Auto is
selected, the BIOS will select the best available option after checking
your hard drive or CD-ROM.
Auto The BIOS will automatically detect the settings for
you.
Disabled The BIOS will not detect these categories.
On-Chip Serial ATA
Disabled
Auto
Combined Mode This option allows you to combine both IDE
Enhanced Mode This option allows you to use both IDE and
SATA Only
Serial ATA Port0 Mode and Serial ATA Port1 Mode
These fields are used to select the master/slave mode of the Serial
ATA drives. Make sure they do not conflict with the settings of the
IDE hard drives.
Disables the onboard SATA.
The system will detect the existing SATA and
IDE drives then automatically set them to the
available master/slave mode.
and SATA drives; supporting maximum of 2
drives on each channel.
SATA drives; allowing a maximum of 6 drives.
This option automatically sets the SATA drives
to Primar y Master mode. Since the SATA
drives are in Master mode, you cannot set the
IDE drive to Master mode.
3
BIOS Setup
73