Table of Contents
Advertisement
2
Hardware Installation
Wake-On-LAN Connector
Your LAN card package should include a cable. Connect one end of
the cable to the wakeup header on the card and the other end to
location J13 on the system board. The network will detect Magic
Packet and assert a wakeup signal to power-up the system. Refer to
the add-in card's manual for details. Note: Your LAN card must sup-
port the remote wake up function.
BIOS Setting
To use the Wake-On-LAN function, you must enable the "Wake Up
On LAN" field in the Power Management Setup submenu of the
BIOS.
48
Parallel
Important:
The 5VSB power source of your power supply must support
≥ 720mA.
WOL
3
Ground
+5VSB
1
Advertisement
Table of Contents
