Table of Contents
Advertisement
SMBus Connector
SMBus
6
2
5
1
The SMBus (System Management Bus) connector is used to connect SMBus devices. It is a
multiple device bus that allows multiple chips to connect to the same bus and enable each one
to act as a master by initiating data transfer.
Chapter 2 Hardware Installation
Chapter 2
S/PDIF Connector
5
SPIN
Ground
SPOUT
NC
S/PDIF
1
+5V
The S/PDIF connector is used to connect an external S/PDIF port. Your S/PDIF port may be
mounted on a card-edge bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then connect the audio cable to the S/PDIF connector. Make sure pin 1
of the audio cable is aligned with pin 1 of the S/PDIF connector.
27
www.dfi.com
Advertisement
Table of Contents
