Table of Contents
Advertisement
If swallowed accidentally, seek medical
advice.
Caution!
Damage to the appliance
Cleaning agents and agents for
pretreating laundry (e.g. stain removers,
prewash sprays, etc.) may cause
damage if they come into contact with
the surfaces of the washing machine.
Do not allow these agents to come into
contact with the surfaces of the washing
machine. If necessary, immediately wipe
away spray residue and other residues/
droplets with a damp cloth.
Notes
When dosing all detergents,
■
cleaning aids and cleaning agents,
always follow the manufacturer's
instructions.
If dosing detergent manually, do not
■
add additional detergent to the
intelligent dosage dispenser (set
intelligent dosage to "off" ö). This will
prevent overdosing and foaming.
Dilute viscous fabric softener and
■
fabric conditioner with water to
prevent blockages.
Dosing and adding detergent:
Pull out the detergent drawer.
1.
Add the correct dosage to
2.
compartment É È depending on:
– Soiling
– Water hardness (ask your water
supply company)
– The amount of laundry
– The manufacturer's instructions
Close the detergent drawer.
3.
Appliance settings
Q
Appliance settings
You can change the following settings:
A p p l i a n c e s e t t i n g s
The volume of the buttons and the
■
information signals (e.g. at the end
of the programme)
Select/deselect the appliance's
■
automatic switch-off function
~ Page 7
Switch the drum-care information
■
signal on/off (depending on the
model). From ~ Page 14 onwards
You will need to activate the setting
mode in order to change these settings.
Activating the setting mode
Press the # button.
1.
The appliance is switched on and
the Cottons programme is shown at
position 1.
Press the Temperature button and,
2.
at the same time, turn the
programme selector clockwise to
position 2. Release the button.
The setting mode is activated and the
preset volume for the information
signals appears in the display panel.
You can now change the settings:
Changing the signal volume
Use the Finish in 0 + or - button to
change the following settings at the
corresponding programme selector
positions:
2: The volume of the information
■
signals and/or
3: The volume of the button signals.
■
en
27
Advertisement
Table of Contents
