Transportation - Siemens WM14T660ME Instruction Manual And Installation Instructions

Table of Contents

Advertisement

Notes
The washing machine must be
correctlyinstalled and connected.
(from ~ Page 38).
Never use a damaged machine.
Inform your customer services.
Preparatory work:
Check the machine.
1.
Fill the ß and i/ß dispensers.
2.
~ Page 24
Remove the protective film from the
3.
control panel.
Connect the mains plug.
4.
Turn the tap on.
5.
Run the programme without laundry.
Switch on the appliance.
1.
Close the door (do not load any
2.
laundry).
Set the Drum Clean 90 °C
3.
programme.
Open the detergent drawer.
4.
Pour approx. 1 litre of water into
5.
compartment É È.
Pour standard detergent into
6.
compartment É È.
To prevent foaming, only use
Note: .
half the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
designed for woollens or delicates.
Close the detergent drawer.
7.
Press the Ü button.
8.
Switch off the appliance at the end of
9.
the programme.
Your washing machine is now ready to
use.

Transportation

E.g. when moving house
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers.
Leaking detergent/fabric softener can
prevent the appliance from working
correctly, e.g. due to damage to the
electronics.
Empty the dispensers before
transporting the appliance.
Positioning and connecting
Preparatory work:
Turn off the tap.
1.
Reduce the water pressure in the
2.
supply hose: ~ Page 31; cleaning
and maintenance – filter in the water
supply clogged
Disconnect the washing machine
3.
from the mains.
Drain any residual water:
4.
~ Page 30; cleaning and
maintenance – drain pump blocked,
emergency draining
Remove the hoses.
5.
Empty the dispensers. ~ Page 29
6.
Installing the transport braces:
Remove the covers and keep them
1.
in a safe place.
Use a screwdriver if necessary.
Insert all four sleeves.
2.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.
Before switching on the appliance
again:
Notes
Always remove the transport braces.
To prevent unused detergent from
flowing straight into the drain during
the next wash: Pour approx. 1 litre of
water into compartment É È and
start the Empty programme.
en
43

Advertisement

Table of Contents
loading

Table of Contents