Table of Contents
Advertisement
Programme default settings
en
Starching
Laundry should not be treated
Note:
with fabric softener.
Switch on the appliance.
1.
Select the Rinse programme.
2.
Pour liquid starch into
3.
compartment É È in accordance
with the manufacturer's instructions
(clean first if necessary).
Press the Ü button.
4.
Dyeing/bleaching
Dye should only be used in normal
household quantities. Salt may damage
stainless steel. Always follow the dye
manufacturer's instructions.
Do not use the washing machine to
bleach clothes.
Soaking
Switch on the appliance.
1.
Select the Cottons 30 °C
2.
programme.
Use i-Dos to dose your detergent or
3.
add it to compartment É È in
accordance with the manufacturer's
instructions.
Press the Ü button. The programme
4.
starts.
After approx. 10 minutes, press the
5.
Ü button to pause the programme.
Leave the laundry to soak for as long
6.
as required, then either press the Ü
button again to continue the
programme or change the
programme.
Notes
Load laundry of the same colour.
■
No additional detergent is required;
■
the soaking solution is used for
washing.
18
0
Programme default
settings
The default programme settings are
P r o g r a m m e d e f a u l t s e t t i n g s
displayed in the display panel after
selecting the programme.
You can change the default settings.
An overview of all programme settings,
which can be selected depending on
the programme, can be found from
~ Page 14.
Temperature
(Temp. °C)
Depending on what stage the
programme is in, you can change the
set temperature before and during the
programme.
The maximum temperature that can be
set depends on the programme that has
been selected.
Spin Speed
(Spin 0)
Depending on what stage the
programme is in, you can change the
spin speed (in rpm; revolutions per
minute) before and during the
programme.
Setting 0: The rinsing water is drained
but there is no final spin. The laundry
stays wet inside the drum, e.g. for items
that should not be spun.
Setting $: Rinse Stop = no final spin.
The laundry stays in the water after the
final rinse.
You can select "Rinse Stop" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the programme has ended.
To continue/end the programme
~ Page 23
The maximum speed that can be set
depends on the model and programme
that has been selected.
Advertisement
Table of Contents
