Table of Contents
Advertisement
Set the programme to position 4.
2.
a The display shows Con.
Press
repeatedly until the dis-
3.
play shows oFF.
a Wi-Fi is deactivated.
Note: The connection is automatically
re-established when the Wi-Fi is
switched back on.
16.5 Resetting the appliance
network settings
Press and hold
1.
3 seconds.
Set the programme to position 5.
2.
a The display shows rES.
Press
.
3.
a The display shows Yes.
Press
.
4.
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
16.6 Remote start
Enable the appliance for remote start
via the Home Connect app.
Activating remote start
Notes
¡ Remote start is deactivated for
safety reasons in the following
circumstances:
– Open the appliance door.
– Press
.
– Press
.
– Switch off the appliance.
– Following a power cut.
¡ Remote start cannot be activated
for safety reasons in the following
circumstances:
– The appliance door is open.
– The detergent drawer has not
been pushed in fully.
for at least
Requirements
¡ The appliance is connected to your
Wi-Fi home network.
¡ The appliance is connected to the
Home Connect app.
¡ A programme is selected.
Press
.
▶
If you press and hold the button
for at least 3 seconds, the
Home Connect menu opens.
If you briefly press the button, the
appliance is enabled for remote
start via the Home Connect app.
If you open the appliance door, the
function is automatically deactiv-
ated.
lights up.
a
Note: To deactivate the function,
press
.
16.7 Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your
appliance will transmit the following
types of data to the Home Connect
server (initial registration):
¡ Unique appliance identification
(consisting of appliance codes as
well as the MAC address of the
Wi-Fi communication module in-
stalled).
¡ Security certificate of the Wi-Fi
communication module (to ensure
a secure data connection).
¡ The current software and hardware
version of your appliance.
¡ Status of any previous reset to
factory settings.
This initial registration prepares the
Home Connect functions for use and
is only required when you want to
use the Home Connect functions for
the first time.
Home Connect en
37
Advertisement
Table of Contents
