The Drain Hose At The Siphon Is Blocked; Filter In The Water Supply Blocked - Siemens WM14T660ME Instruction Manual And Installation Instructions

Turn off the water tap so that no
1.
more water can flow in and has to be
drained via the drain pump.
Switch off the appliance. Pull out the
2.
mains plug.
Open and remove the service flap.
3.
Take the drain hose out of the
4.
retainer.
Remove the sealing cap and pour
the water out into a suitable
container.
Replace the sealing cap and place
the drain hose back in the retainer.
Carefully unscrew the pump cover;
5.
residual water may leak out.
Clean the interior, pump-cover
thread and pump housing. The
impeller in the drain pump must be
able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
Put the service flap back on, lock it
6.
into place and close it.
Cleaning and maintenance
To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash, pour 1 litre of
water into compartment É È and start
the Empty programme.
The drain hose at the siphon
is blocked
Switch off the appliance. Pull out the
1.
mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose; residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
Re-attach the drain hose and secure
4.
the connection point using the hose
clamp.
Filter in the water supply
blocked
First, reduce the water pressure in the
supply hose:
Turn off the tap.
1.
Select any programme (except
2.
Rinse/Spin/Empty).
Press the Ü button. Allow the
3.
programme to run for approximately
40 seconds.
Press the # button. The appliance is
4.
switched off.
en
31