Table of Contents
Advertisement
2.1.3
WiFi / 3G / 4G Antenna Installation
Thread the WiFi / 3G / 4G antenna extension cable through an antenna hole
of the front I/O cover and fasten the antenna as shown below. Then apply
adhesive to the edge of the hex nut behind the front I/O cover to prevent the
extension cable from falling if the cable becomes loose.
1. Thread and fasten the hex nut and the
2. Apply adhesive around here.
washer. Then install the antenna.
Info: The diameter of the nut is around 6.35 mm (0.25"-36UNC).
12
SI-613 User Manual
Advertisement
Table of Contents
