Seek Mode - Listen LR-5200-072 User Manual

Simultaneously press and Hold the DOWN and POWER button for 3 seconds. The unit will display
"Manual" on the display for 3 second and then displays the current channel. If the channel is used
(meaning the Listen Button can select it) the channel will be solid; if not it will flash. Press the LISTEN
button for each selected channel to change between "used" (solid) and "not used" (flashing). Press the
UP/DOWN button to scroll through all available channels. Momentarily press the POWER button to save
and end or after 5 seconds of no activity the setting are saved and the unit returns to normal operation.
Note: The IDSP Software Suite can also be used for set up!
1. Channel
Select Mode:
Press and hold
the Power and
Up button
simultaneously
for 3 seconds
Once the channels have been selected via the Automatic Channel Selection or the Manual
Channel Selection modes a quick change to a specific channel can be made easily. This can be
accomplished by the following process:
Select the channel to be changed via the Listen Button. Press and hold the volume up and down
buttons simultaneously for 5 seconds. The current channel will begin to flash on the display.
Use the volume up or down button to scroll through the available channels. Once the desired
channel is located momentarily press the power button to save and exit the channel select mode
or if no button is pressed for 5 seconds then the selected channel will be saved and the unit will
exit the channel select mode. See pages 21-22 for complete channel selection information.

Seek Mode

Seek Mode is another way to find an active channel in a venue. In the Seek Mode with a press of
the Listen Button the unit searches for and locks onto the next active channel in the list of available
channels. This mode is useful when users are moving from room to room or may not know which
channel to select.
In this mode it is possible that the unit will mistake interference for a real broadcast signal. If you
get interference, press the Seek Button again. The unit may also stop on a channel that is close to the
actual broadcast channel if in the available channel list, in which case the channel will sound noisy
or distorted. Simply press Seek again until you find the clearest operating channel.
4. Save/Exit:
Press power button
to save and exit.
2. Scroll Up/Down:
Use the up or
CH E
down button to
scroll through
available channels
3. Channel Select:
(Listen Button)
Push Listen button to
select the channel
L R - 5 2 0 0 R E C E I V E R M A N U A L
l
PAGE 12