Table of Contents
Advertisement
Push the door downwards again and tighten the screws
7.
hand-tight using a flat-bladed screwdriver (blade width 8-
11 mm), close the door. (Fig. G).
Malfunction table
Malfunctions often have simple explanations. Please refer to the
malfunction table before calling the after-sales service.
If a meal does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
Malfunction table
Problem
The appliance does not work.
"Set clock" appears in the display. The
clock is not showing the current time.
The oven door cannot be opened. The
text "Set clock" appears in the display.
The clock is not showing the current
time.
The oven does not heat up. The text
"Demo" appears in the status bar.
"Automatic switch-off" appears in the
display.
The microwave does not switch on.
The appliance does not heat up to the
temperature which has been set.
Microwave operation has been
cancelled for no apparent reason.
With microwave operation, the food
takes longer to heat up than before.
Error messages with E
If an error message with E is shown in the display, press the
button. Then reset the clock. This cancels the error message. If
the error is shown again, call the after-sales service. With error
Possible cause
Faulty circuit breaker
Plug not plugged in
Power cut
Power cut
Power cut during self-cleaning operation
The oven is in demo mode
Automatic switch-off has been activated.
The oven stops heating.
Door not fully closed.
The microwave was not started.
The
button was not pressed.
n
The microwave has a fault.
The microwave power setting is too low.
A larger amount than usual has been
placed in the appliance.
The food was colder than usual.
0
)
Note: The oven may only be used again when the panels are
correctly installed.
ã=
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Remedy/information
Look in the fuse box and check that the circuit
breaker is in working order.
Plug it in
Check whether the kitchen light works.
Turn the rotary selector to set the current time
then press the
Turn the rotary selector to set the correct time
then press the
cooking compartment has cooled down. The
symbol goes out. You can now open the
L
oven door.
Switch off the circuit breaker in the fuse box
and then switch back on after approx. 20
seconds. Within the next 2 minutes hold the
button down for 4 seconds until "Demo"
D
disappears.
Press any button. The text goes out. You can
make settings again.
Check whether food remains or foreign
material is trapped in the door. Make sure that
the sealing surfaces are clean. Check whether
the door seal is twisted.
Press the
Press the
If this fault occurs repeatedly, please call the
after-sales service. Oven operation without
microwave is possible.
Select a higher power setting.
Double the amount = almost double the time
Stir or turn the food during cooking
messages E101, E104 and E106, you can still operate the
microwave.
If error message E011 is displayed, a button may have become
stuck. Press each button individually and check that they are all
*
button.
0
button. Wait until the
0
button.
n
button.
n
19
Advertisement
Table of Contents
