Table of Contents
Advertisement
Cancelling operation
Press and hold the
n
button until "Select function" appears.
You can now change the settings.
Series of operations
You can use the SeriesOperations function to set up to three
operating modes and then start.
Requirement: you must set a cooking time for each step.
Ovenware
Always use microwave-safe, heat-resistant ovenware.
Setting a series of operations
Set a cooking time for each step in the series of operations.
Press the
2
button.
1.
The button lights up. "SeriesOperations" appears in the
display as the heading. The 1 for the first step in the series of
operations is in brackets.
Select and set the desired operating mode.
2.
Press the
button to return to [1] and use the rotary
Y
3.
selector to select [2] for the second step in the series of
operations.
Time-setting options
You can call up the time-setting options menu by pressing
the
0
button. The following functions are available:
If the oven is switched off:
Setting the timer
■
Setting the clock
■
If the oven is switched on:
Setting the timer
■
Setting the cooking time
■
Setting a later end time
■
Setting the time-setting options in brief
Press the
button to open the menu.
0
1.
Set the desired function by turning the rotary selector.
2.
Press the
button to change line and turn the rotary
X
3.
selector to set the time or cooking time.
Press the
0
button to close the menu.
4.
A detailed description of how to adjust each individual function
is provided below.
Setting the timer
The timer runs independently of the oven. You can use it as a
kitchen timer and set it at any time.
12
Setting a later end time
See the section entitled Time-setting options, Setting a later end
time.
Select and set the desired operating mode.
4.
Press the
button to return to [2] and use the rotary
Y
5.
selector to select [3] for the third step in the series of
operations.
Select and set the desired operating mode.
6.
Press the
n
button.
7.
Appliance operation begins.
Note: The first step in the series of operations appears in the
display. The cooking time starts counting down.
The cooking time has elapsed
A signal sounds. The series of operations is finished. You can
stop the audible signal by pressing the
Changing the setting
Changes can only be made before operation begins.
Press the
Y
button to move upwards until 1, 2 or 3 appears
1.
in the brackets.
Use the rotary selector to select the step that you wish to
2.
change.
Change the setting.
3.
Cancelling operation
Press and hold the
n
button until "Select function" appears.
You can now change the settings.
Press the
0
button.
1.
The time-setting options menu appears.
Press the
button and set the timer run time using the
X
2.
rotary selector.
Press the
button to close the time-setting options menu.
0
3.
The display returns to its previous state. The
timer appears, and the time can be seen counting down.
When the time has elapsed
A signal sounds. The time has elapsed. The display shows
U
00:00. You can cancel the signal earlier by pressing the
button.
Cancelling the timer time
Press the
0
button to open the time-setting options menu.
Press the
X
button and use the rotary selector to turn the time
back to 00:00. Press the
0
Changing the timer time
Press the
0
button to open the time-setting options menu.
Press the
button and in the next few seconds change the
X
timer time by turning the rotary selector. Press the
close the menu.
0
button.
U
symbol for the
button to close the menu.
0
button to
0
Advertisement
Table of Contents
