Yamaha RP-U100 Owner's Manual page 56

Opening Page
Power
STANDBY
ON
Main Panel (Standby) details
Main Panel (On) details
Power Off
OFF
Volume Control
Using the Setup Dialog, you can set the upper volume limit for the volume as
adjusted with the application. This helps to prevent excessively loud settings made by
mistake.
If the volume control on the RP-U100 main unit was used to set the volume to a
level higher than the upper limit for the application, the volume will return to the
upper limit setting the next time the volume control of the application is used.
Note that the volume may sometimes jump up suddenly when the dot on the
application is moved. You should therefore pay attention to the MAX VOLUME
POSITION on the setup dialog.
Setup Dialog details
AC power cord is connected and unit power switch or Application
power button was set to STANDBY.
AC power cord is connected and unit power switch or Application
power button was set to ON.
AC power cord is disconnected.
Volume control
Drag the volume indicator dot around the circumference of the DSP
button.
When the volume indicator is selected, the green dot becomes
red.
To increase the volume, drag the dot clockwise. To decrease the
volume, drag the dot counterclockwise.
Status
Volume
27/68 ページ