Table of Contents
Advertisement
en Fault, what to do?
Fault
Appliance cannot be
switched on or operated.
Appliance does not start.
Programme starts
automatically.
Door does not open
automatically at the end of
the Eco 50° programme.
46
Cause
Malfunction.
The mains fuse has tripped.
Power cord not inserted.
The appliance door has not been
shut properly.
You did not wait until programme
ended.
Eco drying deactivated.
The child-proof lock is activated.
Eco 50° programme not
selected.
Additional functions selected.
ExtraDry is switched on.
Door is not set correctly.
Wrong screws used to adjust the
door gap. If excessively long
screws are screwed in, they may
deactivate Eco drying.
Door and door seal dirty.
Safety device switches the Eco
drying function off. A technical
fault has probably occurred.
Remedial action
Disconnect appliance from the power
supply; pull out the mains plug or switch
off the fuse. Wait at least 5 seconds, then
connect the appliance to the power
supply.
Check mains fuse.
Ensure that the power cord is plugged all
the way into the back of the appliance and
into the socket. Check that the socket
functions.
Close the door.
Perform reset.
Activate Eco drying.
Deactivate the child-proof lock.
Select Eco 50° programme.
Deselect additional functions.
Switch off ExtraDry.
Set the door correctly with the aid of the
installation instructions so that the door
gap is min. 70 mm - 100 mm.
To adjust the door gap, use screws which
have a max. size of ø 4X30 (included in
the product package, see installation
instructions).
Clean door and door seal with a damp
cloth and a little washing-up liquid.
Call the after-sales service.
Advertisement
Table of Contents
