Waste Water Pump - Siemens SN678D10TG Instruction Manual

Table of Contents

Advertisement

en Fault, what to do?

Waste water pump

Large food remnants or foreign objects
which were not captured by the filters
may block the waste water pump. The
rinsing water will then be above the
filter.
:
Warning
Danger of cutting!
Sharp and pointed objects or glass
fragments may block the waste water
pump.
Always carefully remove foreign objects.
Clean the waste water pump as
follows:
Disconnect the dishwasher from the
1.
power supply.
Take out top basket 12 and bottom
2.
basket 1j.
Remove the filters 1Z.
3.
Scoop out water, use a sponge if
4.
required.
Prise off the pump cover (as shown)
5.
using a spoon. Grip the pump cover
by the crosspiece and lift diagonally
inwards (1). Remove cover
completely.
38
Check impeller wheel and remove
6.
any foreign objects.
Place pump cover in the original
7.
position (2) and press down until it
engages (3).
Install filters.
8.
Re-insert baskets.
9.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sx seriesSn seriesSx778d00tg

Table of Contents