Siemens SN678D10TG Instruction Manual page 40

en Fault, what to do?
Fault
Error code ":Ġ is lit.
Error code ":ƒˆ is lit.
A different error code is
indicated on the digital
display.
(":‹‚ to ":„‹)
Refill indicator for salt P
and/or rinse-aid H is lit.
Refill indicator for salt P
and/or rinse-aid H is not
lit.
Water is left in the
appliance at the end of the
programme.
40
Cause
Waste water pump blocked or
cover on the waste water pump is
not locked in position.
Mains voltage too low.
A technical fault has probably
occurred.
No rinse aid.
No salt.
Sensor does not detect salt
tablets.
Refill indicator switched off.
There is still enough special
salt/rinse aid available.
Filter system or area under the
filters 1Z is blocked.
Program has not ended yet.
Remedial action
Clean pump and lock cover correctly.
~ "Waste water pump" on page 38
Not an appliance fault, have the mains
voltage and electrical installation checked.
Switch off the appliance with the ON/OFF
switch (. After a short time restart the
appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the
error code.
Refill rinse aid.
Refill with special salt.
Use different special salt.
Activation/deactivation (see chapter
"Water softening system/Special salt"
~ Page 16 or "Rinse aid" ~ Page 17).
Check refill indicator, levels.
Clean filters and area underneath.
Wait until programme ends or reset.