Operating Costs - Prem-I-Air EH1640 Manual

a.
b.
c.
d.
e.
If the mains lead is damaged, it must be replaced by the manufacturer or an
authorised service centre. If the mains plug needs to be replaced, proceed as
follows:
Connect the brown wire to the terminal labelled "L".
At time of going to press, the average cost of electricity is £0.12 per unit
(kilowatt-hour). The amount you are being charged will be shown on your
electricity bill.
At this cost, the EH1640 will cost £0.19 per hour to run in heating, cooling or
dehumidifying modes, and £0.05 per hour to run in the fan-only mode.
To minimise the power used (and reduce operating costs):
Make sure that the filter is kept clean.
•
Make sure that the air intakes and exhausts are not obstructed.
•
Keep doors and windows closed to prevent conditioned air from
•
escaping, and to prevent exhaust air from re-entering the room.
Use blinds to prevent direct sunlight reaching the room.
•
Set the temperature higher whilst cooling, or lower whilst heating.
•
2834
Remove heat exhaust hose by pushing the clips on the rear
socket to the side with your thumbs, remove and clean with a
soft cloth.
Drain the condensate tank as per the instructions on page 4.
Run the unit in fan only mode for 12 hours to dry out the unit
interior.
Turn off the unit and neatly wrap the power lead round the
storage hooks at the rear of the unit and store the plug in the
storage socket on the reverse of the unit.
Remove batteries from remote control and store in the remote
control storage compartment on the side of the unit.

OPERATING COSTS

Connect the blue wire to the terminal
•
labelled "N".
Connect the green/yellow wire to the
•
terminal labelled with the earth symbol
or "E".
Make sure that the cord-grip is
•
positioned correctly (over the outer
sheath of the cable) and is fully
tightened.
10
Ver. 2 - 04/14