Adjustments - Perlick BBSLP60 Installation & Operation Manual

Commercial Back Bar Installation & Operation Manual
Changing Door Swing Direction
NOTE: Changing the door swing direction is
not advisable if the door is not equipped with
a full length handle. Doing so may result in an
undesirable handle position..
Hinge Kits
Part No. 67439R: Right Hinging
Part No. 67439L: Left Hinging
Tools Required
• Large flat head screwdriver
• Regular Phillips head screwdriver
• Hinge Kit from Perlick
• Plastic putty knife
Procedure
1. Support the door in the open position as
shown in Figure 3. Remove the hinge pin.
Figure 3: Door Removal
2. Pull door to the side and then lower the door.
3. Remove top and bottom hinge brackets.
Retain screws for later use. See Figure 4.
4. Remove the hole plugs from the top and bottom
hinge bracket mounting holes (Figure 4). Place
the plug in the holes on the opposite side made
vacant by removing the hinges in step 3.
Printed in USA

ADJUSTMENTS

5. Using the screws removed in step 3, install
the top and bottom hinge brackets from kit
(Figure 5).
7
Figure 4: Hinge Removal
Figure 5: Hinge Installation
Form No. Z2604
Rev A 01.07.2019