Configure Auto-Switch Of Cameras; Configure Channel-Zero Encoding - HIKVISION DS-7700NXI-I/S Series User Manual

5.4 Configure Auto-Switch of Cameras

You can set the auto-switch of cameras to play in different display modes.
Step 1 Go to System > Live View > General.
Step 2 Set the video output interface, live view mode and dwell time.
 Video Output Interface: Select the video output interface.
 Live View Mode: Select the display mode for live view, e.g., 2*2, 1*5, etc.
 Dwell Time: The time in seconds to dwell between switching of cameras when enabling
auto-switch. The range is from 5s to 300s.
Step 3 Go to View Settings to set the view layout.
Step 4 Click OK to save the settings.

5.5 Configure Channel-Zero Encoding

Purpose:
You can enable the channel-zero encoding when you need to get a remote view of many channels
in real time from web browser or CMS (Client Management System) software, in order to decrease
the bandwidth requirement without affecting the image quality.
Step 1 Go to System > Live View > General.
Step 2 Select the video output interface to Channel-Zero.
Step 3 Go to System > Live View > Channel-Zero.
Step 4 Check the checkbox to enable the channel-zero.
Step 5 Configure the Frame Rate, Max. Bitrate Mode and Max. Bitrate. The higher frame rate and
bitrate settings result in the higher requirement of bandwidth.
Step 6 Click Apply.
Network Video Recorder User Manual
Figure 5-5 Live View- Channel-Zero Encoding
49