Table of Contents
Advertisement
Installing the Hard Drive (Figure 6-19)
1. Install a new drive into the carrier with the printed circuit board side facing down
so that the mounting holes align with those in the carrier.
2. Secure the hard drive by tightening all six screws.
3. Use the open handle to replace the drive tray into the chassis. Make sure the
close the drive tray handle.
SATA Hard Drive
2
2
Drive Tray
Caution: Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the Supermicro
Web site at http://www.supermicro.com/products/nfo/files/storage/SAS-CompList.pdf
Figure 6-18. Installing the Hard Drive
6-19
Chapter 6: Advanced Chassis Setup
1
2
Advertisement
Table of Contents
