Advertisement
Wi-Fi interface introduction
This Wi-Fi interface, communicates the status information and controls the
commands from the server by connecting to the indoor unit.
No Item
1 MODE Button
2 RESET Button
3 ERR LED (Orange) Shows the network error state.
4 NET LED (Green)
5 MODE LED (Orange) Shows the Access Point Mode state.
6 UNIT LED (Green)
(1) MODE Button
WPS-Push mode <For a router with a WPS button>
[To enter the mode]
Hold down the MODE Button for 2 seconds.
[LED indication]
When WPS-Push is enabled on the Wi-Fi interface, the MODE LED starts flashing
orange (every second).
[To cancel the mode]
Hold down the RESET Button for 2 seconds to return to the initial state.
Access Point mode <For a router without a WPS button and to set up with a
smart phone>
[To enter the mode]
Hold down the MODE Button for 7 seconds.
[LED indication]
When Access Point mode is enabled on the Wi-Fi interface, the MODE LED
starts flashing orange (every 5 seconds).
[To cancel the mode]
Hold down the MODE Button for 7 seconds again and ensure that the MODE
LED is no longer flashing.
In any mode, the NET LED will flash when the Wi-Fi interface is connected to the
Router.
Description
Selects modes.
Resets the system and ALL settings.
Shows the network state.
Shows the indoor unit state.
ERR
NET
MODE
UNIT
RESET
MODE
MAC-568IF-E
Wi-Fi
INTERFACE
MODEL
XXXXXXXX
MAC
: XXXXXXXXXXXX
ID
: XXXXXXXXXX
SSID
: XXXXXXXXXXXX
KEY
: XXXXXXXXXXXX
VOLTAGE
:
CURRENT
:
ERR
MITSUBISHI ELECTRIC CORPORATION
NET
MODE
UNIT
RESET
MODE
WiFi.ASSY DWG No.
>PP<
XXXXXXXXXXX
MADE IN CHINA
XXXXXXXXXX
MAC-588IF-E
7
Advertisement
