Advertisement
1
Insert the clip
into place.
3
Corner box
Slip the clip
over the edge of corner box to fix
the interface unit
Example of mounting on the left side of the indoor unit
1
Underside of the
indoor unit
Indoor unit
Corner box
Note: Interface unit
the right side of the indoor unit.
To check the LED indication after setup, remove
the interface unit
10
Holder
Clip
into the holder
until it clicks
Interface
unit
Clip
.
Side of the
indoor unit
Indoor unit
Corner box
can also be mounted on
from the holder
.
2
Holder
Mark for cable
Interface unit
Connecting cable
Insert the interface unit
it clicks into place.
Note: When inserting the interface unit
the holder, align the cable of the interface unit
with the mark for the cable on the holder
Otherwise, light leakage or degradation in
appearance may result.
4
Note: Mount the interface unit
underside of the indoor unit if it cannot be
mounted on the side of the indoor unit.
2
Run the connecting cable in the space on the
back of the unit as shown in the above image.
Tuck cabling away and secure it.
Note: Make sure that the connecting cable will
not get caught on or between the installation
plate and the wall, or between the indoor unit
and the installation plate. Failure to do so may
cause damage to the connecting cable resulting
in communication problems.
Make sure that the connecting cable will not
come out from the indoor unit.
Align
into the holder
until
into
.
on the
Advertisement
