Replacing The Base - Uniden 2.4 Owner's Manual

Call Transfer Feature
1) During a call, press hold/transfer/int'com.
2) Select a handset to transfer the call within 10 seconds.
(Refer to step 2 in the intercom section on page 52).
The call will automatically be placed on hold, and an
intercom tone sounds.
To cancel the transfer, press talk/flash or speaker on
the initiating handset.
3) On the receiving handset, to answer the page, press talk/flash or hold/transfer/int'com.
If you turn AutoTalk on, pick up the handset from the cradle. If Anykey Answer is On,
press any number key,
caller is still on hold.
4) To transfer the call, press end on the initiating handset, and press talk/flash on the
receiving handset.

Replacing the Base

If the base unit is replaced with a different base from this same series of cordless models,
you must clear handset (s) and base identification numbers. To do this, select "System
Reset" from handsets display menu option list (see page 27 for guidance).
w w w . u n i d e n . c o m
/tone/←, or #/→. The intercom mode is activated, but the
*
E X P A N D I N G Y O U R P H O N E [ 5 3 ]
note
For model number
verification, contact
Uniden Customer
Service or visit our
website
www.uniden.com