Setting Advanced Conference Parameters - Huawei TE80 Administrator's Manual

HUAWEI TE80 Videoconferencing Endpoint
Administrator Guide
Parameter
Maximum
incoming call
bandwidth

13.3 Setting Advanced Conference Parameters

Correctly setting advanced conference parameters brings expected conference effects.
Advanced conference parameters apply to the following conferences:



Choose Advanced > Settings > Conference > Advanced. Set the advanced conference
parameters described in
Parameter
Audio and
video protocols
Audio protocol
Audio channels
Video protocol
Issue 02 (2014-03-30)
Description
Specifies the maximum bandwidth allowed
for receiving calls. The bandwidths used for
placing and receiving calls cannot exceed
than this bandwidth.
The settings of this bandwidth and the
settings of Default call bandwidth are
independent of each other.
Point-to-point conferences initiated by your site
Multipoint conferences initiated by your site
Conferences that your site joins by answering a call from a remote site
Table
Table 13-3 Advanced conference parameters
Description
Using the audio or video protocol you
select, your endpoint negotiates the
audio or video capability with a remote
endpoint to set up a call.
If you do not select an audio or video
protocol, this protocol is not an option
value of the related advanced conference
parameters. For example, if you do not
select the H.264 HP protocol, it will not
be displayed in the option values of the
Video protocol parameter.
Specifies the audio protocol your
endpoint uses to encode audio.
Specifies the audio channels.
This parameter is available only when
you select AAC_LD or HWA-LD.
Specifies the video protocol the endpoint
uses to encode video.
During a non-multi-stream conference,
Video protocol is the video protocol the
endpoint uses at your site.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13-3.
13 Feature Configuration
Setting
The default value is 8
Mbps.
The settings cannot
exceed the bandwidth
supported by the endpoint
license.
Setting
Retain the default value.
NOTE
Select at least one audio
protocol and one video
protocol so that you can use
your endpoint to place audio
calls or video calls.
The default value is Auto.
The default value is Two.
The default value is Auto.
To initiate an HD video
conference, select an
H.264-related video
protocol.
139