Setting Snmp Parameters - Huawei TE80 Administrator's Manual

HUAWEI TE80 Videoconferencing Endpoint
Administrator Guide

13.4 Setting SNMP Parameters

To enable the videoconferencing network management system to manage your endpoint,
configure the Simple Network Management Protocol (SNMP) settings.
Your endpoint communicates with and is remotely managed by the videoconferencing
network management system using SNMP. The videoconferencing network management
system implements the following:




On the endpoint web interface, choose System Settings > Network and click the SNMP
Settings tab. Set the SNMP parameters described in
Parameter
Enable
SNMP
Get
community
name
Set
community
name
Trap
community
name
Issue 02 (2014-03-30)
Configures endpoint settings, including the H.323, SIP.
Checks endpoint alarms.
Backs up and restores endpoint settings.
Upgrades the endpoint online.
Table 13-4 SNMP parameters
Description
Specifies whether the videoconferencing
network management system uses SNMP
to manage your endpoint.
NOTE
If you set this parameter to Enable, you must
set other SNMP parameters.
Specifies the read-only SNMP
community name.
Specifies the read-write SNMP
community name.
Specifies the trap community name.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 Feature Configuration
Table 13-4.
Setting
The default value is Enable.
The default value is
Change_Me.
Set this parameter to the value
defined on the
videoconferencing network
management system.
The value is a string of 1 to 32
characters.
The default value is
Change_Me.
Set this parameter to the value
defined on the
videoconferencing network
management system.
The value is a string of 1 to 32
characters.
The default value is
Change_Me.
Set this parameter to the value
defined on the
videoconferencing network
management system.
The value is a string of 1 to 32
143