Setting Network Diagnostics Parameters - Huawei TE80 Administrator's Manual

HUAWEI TE80 Videoconferencing Endpoint
Administrator Guide

13.7 Setting Network Diagnostics Parameters

The firewall protects your IP network by preventing harmful data being passed between the
internal and external networks. Ensure that the firewall settings are applicable to the H.323
videoconferencing system. Otherwise, the system and the firewall will need to be configured
to allow the video conference to pass the firewall.
Choose Advanced > Settings > Network > Firewall. Set the firewall parameters described in
Table
Parameter
H.460
Use NAT
NAT
address
H.323 call
port
RAS source
port
RAS
destination
port
SIP call port
Issue 02 (2014-03-30)
13-7.
Table 13-7 Firewall parameters
Description
Specifies whether H.460 is enabled for
traversal between public and private
networks. If you set this parameter and
Use NAT to Enable, your endpoint will
use Huawei's proprietary Super Network
Passport (SNP). If you set this parameter
to Enable and your endpoint is
recognized as a private network
endpoint, H.460 will be used for
traversal between public and private
networks.
Specifies whether NAT is enabled for
traversal between public and private
networks. An endpoint installed on a
private network is considered as a public
network endpoint after NAT is enabled
on the endpoint. Even if you then enable
H.460 on the endpoint, it is still
considered as a public network endpoint,
and H.460 is not used.
Specifies the public IP address for your
endpoint. This parameter is required after
you set Use NAT to Enable.
Specifies the port a remote site uses to
receive and send call signaling during
communication with your site.
Specifies the port your site uses to
receive and send Registration,
Admission and Status (RAS) signaling
during communication with remote sites.
Specifies the port a remote site uses to
receive and send RAS signaling during
communication with your site.
Specifies the port your site uses to send
Session Initiation Protocol (SIP)
signaling during communication with
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 Feature Configuration
Setting
The default value is Disable.
The default value is Disable.
No default value is set for this
parameter.
The default value is 1720.
Value range: 1-65534.
The default value is 1719.
Value range: 1-65534.
The default value is 1719.
Value range: 1-65534.
The default value is 5060.
Value range: 1-65534.
148