Energy Saver Function; Sleep - Kyocera ECOSYS M2235dn Operation Manual

Installing and Setting up the Machine > Energy Saver function

Energy Saver function

If a certain period of time elapses after the machine is last used, the machine automatically enters sleep mode, which
minimizes power consumption. If the machine is not used while in sleep mode, the power automatically turns off.
NOTE
If user login administration is enabled, you can only change the settings by logging in with administrator privileges.
If user login administration is disabled, the user authentication screen appears. Enter a login user name and
password, and select [Login].
The factory default login user name and login password are set as shown below.
ECOSYS M2235dn/ECOSYS M2735dn

Sleep

To enter Sleep, select the
save a maximum amount of power except the Energy Saver indicator. This status is referred to as Sleep.
If print data is received during Sleep, the machine automatically wakes up and starts printing.
Also when fax data arrives while the machine is in Sleep, the machine automatically wakes up and starts printing.
To resume, perform the following actions.
• Select the [Energy Saver] key.
Recovery time from Sleep Mode is as follows.
• Within 10 seconds
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Model Name
[Energy Saver] key. Message display and all indicators on the operation panel will go out to
Login User Name
3500
Energy Saver indicator
2-20
Login Password
3500