Advertisement
Main
Sub
Contents
code
code
6
01
Paper feed solenoid
(CPFS1, CPFS2, MPFS)
operation check (PSOL
CHK)
02
Resist roller solenoid (RRS)
operation check (RES.R
SOL CHK)
7
01
Check of warm-up display
and aging with JAM (W-UP/
AGING)
06
Interval aging (INTERVAL
AGING)
08
Shift to copy with warm-up
display (W-UP C-MODE)
[Function]
When [OK (ENTER)/START] key is pressed, the selected paper feed solenoid repeats ON for 500ms
and OF for 500ms 20times.
←
→
When [
/
/10KEY] is pressed, the paper feed solenoid setting is switched.
Code number
Setting
0
CPFS1
1
CPFS2
2
MPFS
[Operation]
1) Initial display
06-01 PSOL CHK
0:CPFS1
→
2) [
/10KEY]
06-01 PSOL CHK
1:CPFS2
[Function]
When [OK (ENTER)/START] key is pressed, the resist solenoid repeats ON for 500ms and OFF for
500ms 20 times.
[Operation]
1) Initial display
06-02 RES.R SOL CHK
EXECUTING...
[Function]
Copying is repeated to make the set quantity of copies.
When the test command is executed, warm-up is started and warm-up time is added for every second
from 0 and displayed.
When warm-up is completed, addition is stopped. When [CA] key is pressed, the ready lamp lights up.
After that, enter the copy quantity with [10KEY] and press [OK (ENTER)/START] key to repeat copy-
ing of the set quantity (interval 0sec).
To cancel the test command, turn off the power or execute a test command which causes hardware
reset.
[Operation]
1) Initial display
07-01 W-UP/AGING
[Function]
Copying is repeated to make the set quantity of copies.
When the test command is executed, warm-up is performed and the ready lamp is lighted.
Enter the copy quantity with the [10KEY] and press [OK (ENTER)/START] key, and copying is exe-
cuted to make the set quantity of copies, and the ready state is kept for 3sec, and copying is executed
again to make the set quantity of copies. These operations are repeated.
To cancel the test command, turn off the power or execute a test command which executes hardware
reset.
[Operation]
1) Initial display (Basic display of copy)
READY TO COPY
100%
A4
[Function]
Enter the test command code, and warm-up is started and warm-up time is counted for every second
from 0 and displayed.
When [CA] key is pressed during counting up, "0" is displayed on the display and counting is stopped.
However, warm-up is continued.
After completion of warm-up, counting is terminated. (The aging function is removed from test com-
mand 7-01.)
[Operation]
1) Initial display
07-08 W-UP C-MODE
AR-M150/M155/M155X TEST COMMAND, TROUBLE CODES 10 - 6
Details of function/operation
Operation is possible only when No. 2 cassette is installed.
←
2) [
/10KEY]
06-01 PSOL CHK
2:MPFS
3) [OK (ENTER)/START]
06-01 PSOL CHK
EXECUTING...
4) Returns to the initial display.
2) After 10sec
07-01 W-UP/AGING
0
0
2) After 10sec
07-08 W-UP C-MODE
0
Remark
10
10
Advertisement
