Extech Instruments MO300 User Manual page 10

FCC COMPLIANCE
FCC ID: IWK‐MO300
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
1. This transmitter must not be co‐located or operating in conjunction with any other antenna
or transmitter.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
2.
environment.
To maintain compliance with FCC RF exposure compliance requirements, avoid direct contact
3.
to the transmitting antenna during transmission.
WARNING: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
10
EXTECH INSTRUMENTS
MO300-EN v1.3 5/14