Switching The Server On And Off - Fujitsu PRIMERGY TX2560 M2 Operating Manual

Starting up and operation
6.3

Switching the server on and off

V
CAUTION!
If nothing appears on the screen but flickering stripes after switching
●
on the server, switch the server off immediately (see chapter
"Troubleshooting and tips" on page
The On/Off button does not disconnect the server from the mains
●
voltage. To completely disconnect it from the mains voltage, remove
the power plug(s) from all PSU inlet connectors.
Do not move, strike, or shake the server when it is turned on. This can
●
damage the hard disk in the server and cause data loss.
Turn the server on when the temperature is within its operating
●
environment range (10–35°C). For details on the operating
environment, refer to "Safety Precautions". When operating the
device outside of this operating environment, the server may operate
improperly and data loss may occur. Furthermore, Fujitsu cannot be
held responsible for any related damage, malfunction, or loss of data,
etc.
Be sure to wait for 10 seconds or more after shutdown before turning
●
the server on again.
After connecting all power cords, wait at least 10 seconds before
●
pressing the On/Off button.
Switching the server on
The AC connected indicator lights up green, when the server is off, but
connected to mains.
The controls and indicators are shown in
I
After connecting the server to the mains, it takes about 60 seconds until
power-on becomes possible.
72
83).
figure 7 on page
Operating Manual
61.
TX2560 M2 / RX2560 M2