Table Of Contents - Maytag MLG33 Service Procedures Manual

IMPORTANT
You must disconnect and lockout the electric
supply and the gas supply or the steam supply
before any covers or guards are removed from
the machine to allow access for cleaning,
adjusting, installation, or testing of any equipment
per OSHA (Occupational Safety and Health
Administration) standards.
Please observe all safety precautions
displayed on the equipment and/or specified in
the installation manual included with the dryer.
CAUTION
Dryer(s) should never be left unattended while in
operation.
"Caution: Label all wires prior to disconnection
when servicing controls. Wiring errors can cause
improper operation."
«Attention: Lor des opérations d'entretien des
commandes étiqueter tous fils avant de les
déconnecter. Toute erreur de câblage peut étre
une source de danger et de panne.»
WARNING
Children should not be allowed to play on or near
the dryer(s). Children should be supervised if near
dryer(s) in operation.
Under no circumstances should the dryer door
switch(es), lint door/drawer switch(es), or heat
safety circuit(s) ever be disabled.
The dryer must never be operated with any of the
back guards, outer tops, or service panels
removed. Personal injury or fire could result.
The dryer must never be operated without the lint
filter/screen in place, even if an external lint
collection system is used.
FOR YOUR SAFETY
Do not dry mop heads in the dryer. Do not use
dryer in the presence of dry cleaning fumes.
The dryers must not be installed or stored in
an area where it will be exposed to water
and/or weather.
The wiring diagram for the dryer is located in
the front electrical control box area.

Table of Contents

Part Locations and Removal ................ 4
Lower Front Panel Removal ......................................... 4
Upper Front Panel Removal ......................................... 4
Top Cover Removal ....................................................... 4
Middle Panel Removal .................................................. 4
Lint Box/Blower Assembly Removal ............................. 5
Gas Valve/Ignition System Removal ............................. 5
Oven Chamber Removal ............................................... 6
Gas Valve/Ignition System Components ...................... 6
Oven Housing Components .......................................... 6
Tumbler Support
Wheel Assembly Replacement .................................... 6
Tumbler Alignment ....................................................... 7
Belt Replacement ........................................................ 8
Placing the Belt Back on the Motor Sheave ................. 8
Electrical Component Locations .......... 9
Electrical Panel ........................................................... 9
Sail Switch and Axial Probe Assembly ........................ 9
Exhaust Probe, Exhaust Hi-limit,
and Lint Drawer Switch ................................................ 9