BLADEZ R300II Owner's Manual page 33

Error Message:
E1 (ERROR 1):
Normal state: During workout, if the monitor does not get signal from the adjustment
motor more than 4 seconds and check under successive 3 times then the LCD will show E1.
Power on state: The adjustment motor will return to zero automatically, when the signal
of motor cannot be detected for more than 4 seconds then the adjustment motor's driver
will be cut off immediately and show the E1 on the LCD display. All the other digital and
function mark are blank, and the output signals are cut off also.
E2 (ERROR 2): When the monitor read the memory data, if the I.D. code is not correct or
the memory IC is damaged then the monitor will show E2 immediately at power up.
E3 (ERROR 3): Faulty Motor
Technical data of the current adapter:
Available for Input: 110V/50Hz or 60Hz Output: 6V DC/0.5~1A
LCD WORKOUT GRAPHICS:
Program 1 Manual
Program 4 Rolling
Program 7 Ramp
Program 10 Random
Program 2 Steps
Program 5 Valley
Program 8 Mountain
Program 11 Plateau
Program 13 Precipice
Program 3 Hill
Program 6 Fat Burn
Program 9 Intervals
Program 12 Speedplay
33