Replacing The Hot Surface Ignitor (Hsi) Of The Burner Broil; Nozzle Broil-Burner, And Holder Broil-Burner - Samsung NX58R4311SS Service Manual

3. Disassembly and Reassembly

3-17 Replacing the HOT SURFACE IGNITOR (HSI) of the BURNER BROIL,

NOZZLE Broil-Burner, and HOLDER Broil-BURNER

WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range. Replace all panels before operating range. Failure to do so
can result in death or electrical shock.
WARNING
EXPLOSION, FIRE, AND ASPHYXIATION HAZARD
Shut off gas supply to the range before servicing. Check all gas lines and fittings for leaks before operating
the range. Replace all panels before operating range. Failure to do so can result in death or personal
injury from explosion, fire, or asphyxiation.
CAUTION
When you work on the gas range, be careful when handling sheet metal parts. Sharp edges may be
present, and you can cut yourself if you are not careful.
Parts
Hot Surface
Ignitor (HSI)
Nozzle
Broil-Burner
Holder Broil-
Burner
This document can not be used without Samsung's authorization.
Explanation Photo
Remove the gas nozzle
29
Explanation
1. To replace the HSI of the burner
broil, Remove 2 screws assembled
to HSI
1. To replace the nozzle broil-burner,
Remove the gas nozzle with a
9/32-inch socket wrench.
1. To remove the holder-broil burner,
Remove 2 screws supporting the
holder-broil burner to the rear of
the oven.
2. When the service is complete,
reverse the order to install burner
broil, HSI, Nozzle and Holder broil
burner.
NOTE: The oven burner flames can
be adjusted by loosening the
locking screw and opening or
closing the air shutter at the
base of the oven burner.