Samsung NX58R4311SS Service Manual page 13

3. Disassembly and Reassembly
3-2 Removing the Rear Cover Panels
Parts
Cover-Back Main
Wire
PCB Assembly &
Spark Module
This document can not be used without Samsung's authorization.
(cont.)
Explanation Photo
PCB assembly Spark Module
13
Explanation
7. Remove 9 screws and pull out
the cover from the middle back
of the range
8. Remove screws of PCB
assembly and separate PCB
assembly. (When you check
PCB, check the proper PCB in
default mode and check main
PCB.)
9. Disconnect the wires to the
spark module to remove it.
10. Remove 2 screws and the
spark module from the back of
the range.
11. Disconnect the wire connectors
from the terminal on the spark
module.
12. When service is complete,
replace the five cover panels
on the back of the range
and secure each with the
appropriate screws.
13. Replace the PCB ASSEMBLY
and the spark module.
14. Reconnect the gas supply line
to the range, if removed. Open
the main gas shut-off valve and
check for gas leaks.
15. Plug in the range and/or turn
on the electrical supply to the
range.
16. Push the range back in place,
making sure to engage the
anti-tip bracket on the left-rear
leveling leg.