Cleaning The Dust Bin Filter - LG VR668 VW Series Owner's Manual

CLEANING THE DUST BIN FILTER

The Dust Bin Filter consists of a Particulate and Sponge Filter.
Clean both the Particulate and Sponge filters as per the following sequence.
1. Pull the hook on the left of the Particulate
filter module on the rear side of Dust Bin
to separate the Particulate filter and the
sponge.
2. Thoroughly clean out the fine dust particles on the
Particulate filter, with a vacuum cleaner or cleaning
brush.
※ Do NOT wash the Particulate filter with water.
Its suction power will be reduced.
3. Use a cleaning brush to clean the Sponge Filter.
If using water to clean it, allow it to dry completely
in the shade before refitting.
4. Assemble the Particulate and Sponge filters
back onto the Filter housing as per the
following sequence.
※ Fit the rectangular locator on the Particulate
filter into the locating slot of the filter body.
※ Be careful not to incorrectly assemble
Particulate and Sponge Filter onto the Filter
housing.
Tip
• To preserve the performance of the Robot Cleaner, clean the Particulate filter at least
once a week, with a brush or vacuum cleaner.
• The Particulate and sponge filters must be fitted to the filter housing before refitting the
filter to the dust bin. Operating the Robot cleaner without the Particulate and sponge
filters will cause the suction motor to malfunction and will be evident when assessed by a
technician, and would not be covered under the warranty.
42