Cleaning The Dust Bin Filter - LG VRD830MGPCM Manual

The Dust Bin Filter consists of a EPA Filter and Sponge Filter.
Clean both the EPA and Sponge filters as per the following sequence.
1. Pull the hook on the left of the EPA Filter
module on the rear side of Dust Bin to
separate the EPA Filter and the sponge.
2. Thoroughly clean out the fine dust particles on
the EPA Filter, with a vacuum cleaner or cleaning
brush.
※ Do NOT wash the EPA Filter with water.
Its suction power will be reduced.
3. Use a cleaning brush to clean the Sponge Filter.
If using water to clean it, allow it to dry completely
in the shade before refitting.
4. Assemble the EPA and Sponge filters back
onto the Filter housing as per the following
sequence.
※ Fit the rectangular locator on the EPA Filter
into the locating slot of the filter body.
※ Be careful not to incorrectly assemble EPA
and Sponge Filter onto the Filter housing.
Tip
• To preserve the performance of the Robot Cleaner, clean the EPA Filter at least once a
week, with a brush or vacuum cleaner.
• The EPA and sponge filters must be fitted to the filter housing before refitting the filter
to the dust bin. Operating the Robot cleaner without the EPA and sponge filters will
cause the suction motor to malfunction.

CLEANING THE DUST BIN FILTER

31