Cleaning The Dust Bin Filter - LG ROBOKING VR644 Series Owner's Manual

The Dust Bin Filter consists of a HEPA Filter and Sponge Filter.
Clean both the HEPA and Sponge filters as per the following sequence.
1. Pull the hook on the left of the HEPA Filter
module on the rear side of Dust Bin to separate
the HEPA Filter and the sponge.
2. Thoroughly clean out the fine dust particles on the
HEPA Filter, with a vacuum cleaner or cleaning brush.
※ Do NOT wash the HEPA Filter with water.
Its suction power will be reduced.
3. Use a cleaning brush to clean the Sponge Filter.
If using water to clean it, allow it to dry completely
in the shade before refitting.
4. Assemble the HEPA and Sponge filters back onto
the Filter housing as per the following sequence.
※ Fit the rectangular locator on the HEPA Filter
into the locating slot of the filter body.
※ Be careful not to incorrectly assemble HEPA
and Sponge Filter onto the Filter housing.
Tip
• To preserve the performance of the Robot Cleaner, clean the HEPA Filter at least once a week,
with a brush or vacuum cleaner.
• The HEPA and sponge filters must be fitted to the filter housing before refitting the filter to
the dust bin. Operating the Robot cleaner without the HEPA and sponge filters will cause the
suction motor to malfunction.

CLEANING THE DUST BIN FILTER

27