Advertisement
Set up the lamp to the suspended ceiling as it is shown bellow (Required opening 110mm):
Step 1
Bend the springs, to get into the hole of the suspended ceiling, as you can see to the next figure.
Step 2
Push up the luminaire, as shown in figure 2.
Step 3
Continue to push upwards until the lamp locks.
Install the luminaire according to the following
Step 1. Follow the step 1 of the installation instructions.
Step 2. Unfasten the retaining screw (Figure 4) and detach the part for suspended ceiling installation.
Step 3.
Drill 2 holes on the base using a 4mm drill bit in order to permit the retaining screws to pass. Mark
these two drilled points on the required mounting location, drill the holes and install the supplied
plastic plugs.
on the ceiling you must align the base with the indications on the luminaire's base (Figure 5).
Step 4. Install the decorative rim (package included).
require location.
Step 5. Follow the step 3 of the installation instructions.
Retaining fastener
Page 4 from 6
Mounting the lamp in suspended ceiling
Figure 1
Figure 2
Figure 3
If you want to pull off the device, put a flat blade
screwdriver, between the device and the ceiling.
SURFACE MOUNTING
ATTENTION!! Especially for the GR-290/M and GR-292/M luminaire installation
Figure 4
steps:
Next, use the 2 fasteners to install the unit to the
Drill here
Ø110mm
Indications
Figure 5
923293003_09_006
Advertisement
