Table of Contents
Advertisement
Power and ZigBee Network LED indication.
PWR
STACK
NTWRK STATUS 1, 2
Z-2400-A2I Dip Switch Positions for Input to Output Installations.
For the Input to Output Link (Z-2400-A2I to Z-2400-A2O), please check that
the dip switch positions are exactly as shown, as any out of place switches
will result in a wireless link failure.
The Z-2400-A2I can be configured via the dip switches on the side to work
alongside Intech's other ZigBee® link, the Z-2400-RB or Z-2400-TCP base
node, so that the analogue and digital input/outputs are communicating
directly with MicroScan SCADA software. For this you can purchase the
Z-2400-A2I as an individual unit.
ZigBee Mesh ID.
The reason for Mesh IDs is to allow for multiple wireless Bases (Z-2400-A2O, Z-2400-RB & Z-2400-TCP) and therefore
networks to be used in the same location where the Mesh signals will overlap. You can program the Mesh ID of the
Repeater node via the 'uP Configure' software. The Input and Output nodes are supplied paired with a unique ID.
Programming the Z-2400-A2 Series.
uP Configure Software.
The 'uP Configure' software is free to download from Intech's website:
www.intech.co.nz/downloads
uP Configure (version 1.2.8.0 or later) offers a smart, no-fuss setup experience for your Z-2400-A2 wireless nodes.
It allows you to:
Set up the analogue input types of the Z-2400-A2I (Default input is 4~20mA).
Configure the digital inputs and outputs between Z-2400-A2I and Z-2400-A2O nodes.
Set unique ZigBee Mesh ID networks to pair your Z-2400-A2 devices. (The Input and Output nodes are
supplied paired to each other with a unique Mesh ID, however the Repeater will always need to be paired to the
unique Mesh ID.)
Configure the RF output to comply with the wireless standards of your region.
If you are programming the Z-2400-A2I for a MicroScan installation, then you must use 'XU Setup' software, refer to the
'Z-2400-A2I MicroScan Installation Guide'.
Installing uP Configure.
Note: You must install uP Configure before connecting a Z-2400-A2 wireless node to your computer. If you have
already connected the wireless node using the XU-USB key, please disconnect it before continuing.
1.
Download the latest version of uP Configure from
For ease of access, we recommend saving the install file on your desktop. If you cannot locate the install file,
check whether your browser has saved it in your Downloads folder.
2.
Extract the install file from the zip folder. Right-click on the zip folder and choose 'Extract All', (or extract the file
using another extraction utility of your choice).
3.
Double-click on the extracted 'uPConfigure.msi' install file. This will launch the uP Configure installer.
Depending on your security settings, a 'Security Warning' dialogue may appear. If you see the security message,
click 'Run'. A Windows User Account Control window may also appear. Click 'Yes' to continue.
ON indicates power supplied connected.
®
Flashes when ZigBee
communication is active.
See Previous table.
ON
OFF 1~5, 7
www.intech.co.nz/downloads
8
Z-2400-A2IO Positions
6, 8
ON Position
OFF Position
Advertisement
Table of Contents
