Using The Up Configure Software - Version 1.2.8.0 Or Later; Configuring The Z-2400-A2O - Intech Instruments Z-2400-A2 Series Installation Manual

Using the uP Configure Software - version 1.2.8.0 or later.

To run uP Configure, double click on the icon on your desktop.

Configuring the Z-2400-A2O:

Starting with your Z-2400-A2O connected to your computer via the XU-USB programming key, Click on the Connect
button. The next screen that comes up is the 'Overview' of the Z-2400-A2 node connected.
uP Configure Overview Screen
Wireless Transmit Power
Remember to ALWAYS click the 'Apply' button after you change any settings, this will program the new settings to your
Z-2400-A2O node.
uP Configure Home Screen
To disconnect the Z-2400-A2O node from your computer, click on Disconnect in the top
right corner of the screen.
This screen shows:
 which node is connected by highlighting it in
orange.
 The Mesh ID assigned to that unit.
 The Wireless Transmit Power setting.
The only requirement to set up the
Z-2400-A2O is the 'Wireless Transmit
Power'. Click on the drop down menu
as shown where you can select your
region.
This setting is important and must
be set to comply with the wireless
standards of your area.
10