Table of Contents
Advertisement
Configuring the Z-2400-A2I:
The Z-2400-A2I Input node connects to your computer the same as the Z-2400-A2O Output node, via the XU-USB
programming key. Click on the Connect button in the uP Configure software to get started.
The Overview page also has the same information: node type, Mesh ID and Transmit Power. You'll also notice a row of
tabs across the top left hand side of the screen for setting up the inputs, outputs and setpoints.
Wireless Transmit Power:
The first parameter to configure is the 'Wireless Transmit Power'. Click on the drop down menu as shown and select
your region. This setting is important and must be set to comply with the wireless standards of your area.
Z-2400-A2I Analogue Input Configurations
Display Value: The 'Display Value' is an area between transmission to give an incoming analogue signal meaning.
For example: A 4~20mA input from a pressure sensor = a display value of 0~100(kPa).
Z-2400-A2I Overview
Input Mode: This drop down menu is where you select
your input type such as Temperature, 4~20mA, Voltage
etc. (Default = 4~20mA.)
Input Type: This is the sub menu of the Input Mode where
you can set next level of input type, such as an RTD or
thermocouple etc.
Sensor Type: This drop down menu is for inputs that have
a specific sensor type, eg RTD with a Pt100 sensor, or
thermocouple with a type K sensor.
Temperature Scale: The temperature scale is visible for
temperature sensor types (RTDs/Thermocouples) and
allows you to set for °C or °F.
Input Range: Input range is the sub menu for value related
input types such as 4~20mA for mA type, or 0~10Vdc for
Voltage type etc.
11
Mesh ID
If for any reason you have to
replace the Input or Output node,
you can change the Mesh ID of
the Input node to match the
Output node.
Note: The Z-2400-A2IO, Input
and Output node kit, are
supplied together with matching
unique Mesh IDs.
To configure the Analogue inputs,
click on the 'Input/Output' tab at the
top. Here you can go through each
drop down menu and each value
box to configure the inputs to your
required input type.
Advertisement
Table of Contents
