Digital Input 1~4 Specifications; Digital Output 3~4 Specifications; Relay Output 1~2 Specifications; Analogue Output 1~2 Specifications - Intech Instruments Z-2400-A2 Series Installation Manual

Digital Input 1~4 Specifications.

Frequency Range
Input Threshold
Maximum Amplitude
Open Collector Excitation
Isolation

Digital Output 3~4 Specifications.

Relay Output 1~2 Specifications.

Functions
Relay Rating
Isolation to Sensor and Input Commons
Default State
Approved to Standard

Analogue Output 1~2 Specifications.

mA Range
Resolution
Output Drive
Linearity & Repeatability
Accuracy
Ambient Drift
Isolation to Digital I/O GND

General Specifications.

Power:
Supply Voltage
Consumption
Isolation
Environment:
Operating Temperature
Storage Temperature
Operating Humidity
Altitude
Transmission:
RF Data Rate
RF Frequency
RF Channels
RF Power
Spreading Method
Modulation
Nodes
Antenna Connection
Tx Range
Tx Power
Rx Sensitivity
Connection Indication
Multiple Mesh Use
Default Mesh ID
Link Connection Time
Programming Port:
Compliances:
FCC Regulation
Radio Equipment and Systems
EMC Compliances
Case:
Enclosure Rating
Node Weight
Dimensions (No Antenna)
0~1Hz.
1.4Vdc.
30Vdc continuous.
3Vdc.
Not isolated to the power supply common.
Open-Drain, 30Vdc, 1A Max. (Not isolated to the power supply common.)
2 on Board Controllers can be used as Set Point (SV), Switching Differential,
Auto/Manual, Manual Output Setting, Dual Action Control, Single Action Control,
Heat/Cool, Cool Only, Heat Only.
Form A Relay, 250Vac/30Vdc, 5A Max.
2300Vrms for 1min. Working voltage 30Vdc.
Normally Open.
UL.
2 Isolated Analogue Outputs (not isolated from each other).
4~20mA Loop Powered.
15bit, 16000 steps.
700Ω Max @ 24Vdc Supply.
0.1% FSO Max.
0.1% FSO.
50ppm/°C FSO Max.
1400Vrms for 1min. Working voltage 125Vdc.
9~36Vdc.
2.5VA Max.
1500Vac between power supply and input/output channels.
-20~+55°C.
-20~+65°C.
0~85%.
2000m.
250Kb/s.
2405~2475MHz.
15.
10mW or 100mW (User Selectable to comply with region wireless standards).
Direct Sequence.
O-QPSK.
1 Output Base, 1 Input Remote, and up-to 15 Repeaters per mesh network max.
RP-SMA.
~4.0Km (supplied antenna line of sight, Reduces to 50m typical with major obstruction).
+10dBm or +20dBm (User Selectable to comply with region wireless standards).
-110dBm.
Toggling LEDs.
Mesh ID 0~255.
1 (1, 2, 3, 4, 5, 6, 7, 8).
Time to Connect: Less than 1 Minute (No Repeater).
Link Failure: 1 Minute.
Programmable via XU-USB Key.
2ACTT-1409.
AS/ANS 4268:2012.
ETSI EN 300 440-2, V1.4.1, 2010.
EN 301 489-3, V1.6.1, 2013.
35mm DIN Rail Mount.
IP20.
Z-2400-A2I/A2O 0.15Kg, Z-2400-A2R 0.10Kg.
H=104mm, W=24mm, D=120mm.
5