Diagnostic Leds; Rf Signal Quality Led Indication; Output, Input And Repeater Node Network Status Led Definitions - Intech Instruments Z-2400-A2 Series Installation Manual

Diagnostic LEDs.

RF Signal Strength LED indication.
Each LED corresponds to the measured signal quality levels:
 One illuminated LED indicates very weak or no signal.
 Two illuminated LED's indicates low signal level.
 Three illuminated LED's indicates medium signal level.
 Four illuminated LED's indicate high signal level.
Z-2400-A2I
Low Signal Level from
Input node to Repeater node.

Output, Input and Repeater Node Network Status LED Definitions.

Z-2400-A2 node is not running.
Output node is booting.
Output node is forming the network.
Output node has reached maximum
repeater node capacity in network.
Output node has formed network and
is ready to receive a transmission.
OFF
Output Network Status:
1 = ON, 2= OFF
1, 2 Toggle
Input Network Status:
2 = ON/Flashing, 1=OFF
1, 2 Toggle
1, 2 Flash at same time
Z-2400-A2R
Medium Signal Level from
Repeater node to Output node.
ON Flashing
Output node starting up.
Network formed ready to connect.
Input / Repeater node starting up.
Input / Repeater node connected to network.
Input / Repeater node NOT connected.
(Output not running, or no signal getting through or wrong Mesh ID set.)
Z-2400-A2 node is faulty.
Input / Repeater node is booting.
Input / Repeater node is searching for
the network.
Input / Repeater node can not
detect the network.
Input / Repeater node found the
network and are ready to transmit.
Toggling
7
Z-2400-A2O
Medium Signal Level from
Output node to Repeater node.