Table of Contents
Advertisement
1. Among the Setup options, click PTZ Limits.
2. To limit the maximum movement range, you can do one of the following:
In the image panel, move the PTZ camera as far left as you want to display then click the From
l
icon for the Pan Limit. Move the camera to the farthest point to the right and click the To
Repeat this procedure for the Tilt Limit, only move the camera up and down. For information about
moving the PTZ camera, see Using the PTZ Camera Controls on page 4.
Below the image panel, you can set the Pan and Tilt Limit by adjusting the position of the two black
l
dots on each circle. The gray area shows the set degree of movement. The Pan Limit sets the
horizontal movement range and the Tilt Limit sets the vertical movement range.
3. To set the Lens Zoom Limit, enter a maximum zoom level.
4. To set the Maximum Move Speed, enter a maximum number of degrees per second.
5. To allow the camera to automatically correct the video image when the camera tilts more than 90°, select
the Enable E-Flip check box. When this option is disabled, the video image is upside down when the
camera tilts more than 90°.
6. Click Apply to save your settings.
30
icon.
PTZ Limits
Advertisement
Table of Contents
